[adamant]

Howdy folks,

X2 is huge as has my system tied up.

I'd like to just open cimco editor but I have "no hasp". The hasp is a network hasp, with not enough to go around. There is a little used Lathe hasp that is all I need, but I don't know how to make my machine default to it. Going to get the tech guys involved today........Thought I'd throw it out here though and see if anyone had a simple fix.....heh.

[cadcam]

if there is a stand alone lathe lic that you can pull go to your Icone on the desk top right click go to Properties and look at the target cahnge to example (E:\McamX2\mastercam.exe /L1 this will tell the Nethasp to just pull a Lathe1 lic. PS Cimco is not part of Mastercam X or higher.

[adamant]

PS Cimco is not part of Mastercam X or higher.

Ok, thanks for the info........I'll give er a shot.

Where is the Editor for x2? I looked for it today and could not find it............

[cadcam]

Here is were in the "Settings" "Config" were the option of editors is in X2
If you have V9 on the same box you can use the Cimco editor from there by using the "other" option in the edtitors choice box and point to the Mcedit.exe file in V9.