[steve0311]

Any help would be greatly appreciated. Machine ran all last week perfectly. Turned it on this morning and got the following alarms
391: Servo Pack Alarm (x)
361: PG error (x)
351: OL (x)
310: Servo off

I can't do anything. I turned axis by hand off switches. It turns out the operator may have shut the machine down on Friday during a homing cycle but not sure.

If you can provide any advice, I would greatly appreciate it.

Thanks in advance

[steve0311]

Hello,
If it helps, I found that the power light on the servo pack is not lit. I don't know what would cause this.

Thanks Again

[shas595]

Steve, (if that is your name!)

Those alarms are telling you the servo in question in of; could be powered but not in a ready state. What is the model of the servo. Does it have the DRO on it or just two lights (run & ready)

Likely the turning off during a home cycle *shouldn't* be the cause; but stranger things have happened. Let me know that info and we will more forward

John