Hi all,
Needs some help I have a small hobby mill from open builds running Mach 3, G540, ESS. I down loaded Vectric Aspire demo to design a dust boot, finished the design and find out you can't save the G-code. So I send off a DFX of the design to a friend that does pearl inlay with Vectric to save the design to Mach2/3 arcs.txt, He sent it back to me and loaded it up. Heres the problem all the dust boot plates show up the material on the top right hand side (picture attached). I have reinstalled Mach 3 and tried setting IJ to incremental in General settings. the design should be in the centre of a 220mm x 150mm 10mm work piece of acrylic. Every thing shows in the right place in Aspire is there something I am not doing in the design side that would cause this. I am also trying to to learn Fusion 360 but I drowning on the CAM side and was told by mate to try Vectric software which is great to use. Appreciate any help.
Cheers
Peter