Hi all,
I am new to these forums and was hoping this might be the place to get some help on an issue I am having with my chinese laser.
I have a 60 watt 600x900 laser from Gweike that has been running great for 3 years. Control card is MPC 6525. Recently I replaced the pc that runs the laser. I installed LaserCut 5.3 etc and it seemed as though everything was going to run smoothly on the new computer.
Problem is when I upload a job to the laser from LaserCut and press start, the head moves to start the job and just hangs there, laser firing in one spot. If I hit "Test" it will contour the job fine.
Also, when going to move the head or even the z axis I will tap the arrow once but the head or table will just keep moving until I power off the machine.
Frustrated, I connected the old computer back up and it doesn't work on that now either.
Anyone have any ideas on how I can get up and running again??
Thanks.