I was just running the following code and had a crash happen. I can't figure out why! It did the first section perfectly then got to the M01 position. After I hit start it moved to the x,y position but also moved in Z down into the part at the same time. Can anyone tell me why this would have happened?
N100 (Machine Setup - 1 Center Drill)
(RETURN PINS - 0.3760)
T5 M06
S681 M03
G00 G54 X-3.5 Y0.75
G43 H5 Z1. M08
Z0.2
G81 X-3.5 Y0.75 Z-0.08 R0.1 F0.9534 G98
Y-0.75
X3.5
Y0.75
G80
G00 Z1.
N102 (Machine Setup - 1 Center Drill)
(CENTER EJECTORS - 0.2810)
T5 M06
M01
S681 M03
G00 G54 X0. Y0.875
G43 H5 Z1. M08
Z0.2
G81 X0. Y0.875 Z-0.08 R0.1 F0.9534 G98
Y-0.875
G80
G00 Z1.