[jaysmusgrave]

I'm new to HAAS live tooling programing and finding it frustrating to work out on my own. At the moment I am just trying to drill a hole right through the middle of a part with a 3/4 end mill. I'm currently using G83, only because I don't know what else to use. I can't find a clear example of simply drilling a hole anywhere and it's frustrating because it's so simple to do on my Mori. Here is the exact program I'm using:

M01
T303
G98
M154
G00 G54 X6. C0. Y0. Z1.
G00 X0. Z.25
G97 P1500 M133
M08
G83 G98 C45. Z-.660 F5. Q.15
C135.
C225.
C315.
G00 G80 Z.5 M09
M155
M135
G28 H0.
G00 X8. Z10.

I built this code following an example I found online but it isn't working. It throws an alarm right after the C Axis engages. It says the "V Axis Disabled." I've tried several different variations, but each time I get an alarm. Please advise on how I should go about this.

[Heavy_Metal]

Hi,

Maybe the Haas PDF can help.

Regards,
Heavy_Metal.

[jaysmusgrave]

Turns out the problem was in the parameters, 315 to be exact. Found the answer within the manual you sent, thank you.

[Heavy_Metal]

Hi,

Check this website for other HAAS manuals.

Haas Automation

Regards,
Heavy_Metal.