I am using a tsugami S25 lathe to make a 2" long Dowel Pin. I am using material that is .505 in dia. and I have the radius on the front programed and its working fine. I am not turning down the Dia at all. On the back side I am using a cutoff to do a plunge cut. then pull the material in a little and finish the negative radius. I have the radius programed but I cant get the correct length on the radius
%
:7000( 8/3/16 S25)
M8
G0G20G40G97G99T2100M11
G110G28
G300X.100Z2.287B6.693T1707
G50X.100Z-.010M10S5200
G0X2.200Z-.050

T1303M13G96S300
G0X.822Z-0.01
G1X-0.030F.0015
G1X.386F.0058
G2X0.510Z0.070R0.125F.003
G1Z2.0F0.05
G4P100

T1707M03G96S300(C-O)
M8
/M56
/M58
G50W-.087S3000
G0X.605Z2.0 (OAL)
G1X.400F.001 (plunge cut)
G0X.605 (cut off backs out)
Z1.75 (pull material back in for radius)
G1X0.490F.002 (bring cut off close to material)
Z2.0F.001R-0.095 (apply radius) I cant get the length to 0.062 the current length is .038
X0.300
/M21
/M56
/M53
/G110G0B2.5
/G110G1B.300F50.0
/G141
/M20
/M58
G1X0.30F0.001
G1X-0.03F0.001
/G140
M5G97

I appreciate any help I can get..