586,075 active members*
4,151 visitors online*
Register for free
Login

Thread: Connecting to controller

Results 1 to 3 of 3
  1. 08-15-2016, 11:00 AM #1
    necromanteion
    necromanteion is offline Registered
    Join Date
    May 2016
    Posts
    3

    Connecting to controller

    Hello everyone ,
    i have a 50w Chinese laser that was working fine, during the last job while sliding up the Y axis I heard a little clunk, the machine froze up. So after a while I turned it off , now it won't initialize, all I get on the display is connecting to controller message, I am getting desperate, any help would be apreciatade, thank you in advance for any help, tips or ideas.

    regards,
    Jack Jacinto
    Reply With Quote Reply With Quote
  2. 08-16-2016, 11:21 AM #2
    cinematic2
    cinematic2 is offline Member
    Join Date
    Nov 2010
    Posts
    787

    Re: Connecting to controller

    Any info about this machine would help.
    CNC lasers, constructions, service
    Reply With Quote Reply With Quote
  3. 08-16-2016, 11:13 PM #3
    necromanteion
    necromanteion is offline Registered
    Join Date
    May 2016
    Posts
    3

    Re: Connecting to controller

    Hi cinematic2,

    My laser engraver is a HPcutter Co2 Laser Engraver 50W (chinese laser) https://www.amazon.co.uk/HPcutter-En.../dp/B011KKMKJ2
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Connecting DNC OR CMT to a mazak m-32 controller
    By toolmaker23 in forum Controller & Computer Solutions
    Replies: 0
    Last Post: 03-12-2010, 07:32 AM
  2. Struggling connecting Mach3 to a controller
    By zaebis in forum Mach Software (ArtSoft software)
    Replies: 5
    Last Post: 07-25-2009, 02:09 AM
  3. Connecting an 8-Pin Stepper so a 6-Pin controller
    By sw_ in forum CNC Machine Related Electronics
    Replies: 2
    Last Post: 03-10-2008, 09:36 PM
  4. Connecting controller with this motor
    By tom1975 in forum CNC Machine Related Electronics
    Replies: 0
    Last Post: 09-16-2007, 10:27 PM
  5. Connecting a Controller Board
    By kpkale in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 7
    Last Post: 07-29-2007, 03:16 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules