586,094 active members*
4,050 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Servo Motors / Drives > Mitsubishi HD80 Torque value

Thread: Mitsubishi HD80 Torque value

Results 1 to 2 of 2
  1. 08-18-2016, 12:35 AM #1
    niteennatu
    niteennatu is offline Registered
    Join Date
    Aug 2007
    Posts
    4

    Mitsubishi HD80 Torque value

    I have to change Mitsubishi HD 80-10S and HD 80-12S motors on Mazak machine. Can any body tell the Torque of these motors
    Please reply
    Reply With Quote Reply With Quote
  2. 08-30-2016, 01:22 AM #2
    mmurray70
    mmurray70 is offline Registered
    Join Date
    May 2012
    Posts
    537

    Re: Mitsubishi HD80 Torque value

    Not alot of help, but heres the manual for the drive for these motors. looks like 170v drive (i think) and the HD-80 motors are rated at 10a. My machine uses HD-8011s and uses TRA 30C drive which has a peak output of 45amps. might be some help for comparing sizes.

    Also for what its worth, I almost replaced these motors for new units from DMM Tech and after sending DMM the info on my ballscrews and machine they reccomended 1.0kw replacements. Good luck with it.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. mitsubishi meldas 320 spindle motor parameter help Mitsubishi AC spindle SJ-N 5.5k
    By geobuild in forum Mitsubishi controls
    Replies: 1
    Last Post: 12-26-2015, 03:39 PM
  2. Constant Torque vs. Varaible Torque VFD
    By robhrzic in forum Phase Converters
    Replies: 24
    Last Post: 02-17-2012, 02:46 AM
  3. Drive torque and pull out torque
    By bpp in forum Stepper Motors / Drives
    Replies: 1
    Last Post: 10-29-2011, 11:14 PM
  4. Holding torque vs rotational torque ?
    By SScnc in forum DIY CNC Router Table Machines
    Replies: 11
    Last Post: 05-06-2010, 01:41 PM
  5. higher torque 5 start, vs lower torque 2 start
    By carvemylog in forum DIY CNC Router Table Machines
    Replies: 8
    Last Post: 03-12-2009, 04:44 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules