I was machining a part on our Vf-2 yesterday and everything was going finr then when it went to do the finish pass and alarm came up and said "cutter compensation interference" #367. what does this mean? is there a problem with our new machine or is there a problem with the programmer(me)?
Thread: Alarm 367?!
Results 1 to 3 of 3
-
02-01-2007, 07:46 PM #1
Registered
- Join Date
- Jan 2007
- Posts
- 51
Alarm 367?!
-
02-01-2007, 08:21 PM #2
Registered
- Join Date
- Aug 2005
- Posts
- 578
My VF book sez that the G01 can not be done with cutter size. Therefore I gotta think that you are using comp in the control and inputting a dia in the geometry page and that the G01 value at your lead in is less than teh radius of the tool.
Personaly I use wear comp so that I don't put a value in the dia on the geo page and when I comp it's a +or - small number.
-
02-01-2007, 08:23 PM #3
Registered
- Join Date
- Jan 2007
- Posts
- 51
thanks
Reply With QuoteSimilar Threads
-
Amp Alarm
By bbrreid in forum CNC Machine Related ElectronicsReplies: 4Last Post: 03-01-2012, 12:13 AM -
205 p/s alarm
By bink in forum FanucReplies: 0Last Post: 12-09-2006, 04:04 AM -
alarm #180
By j-radkemachine in forum Haas MillsReplies: 1Last Post: 07-20-2006, 07:34 PM -
Ps-012 Alarm For T15
By Mircea in forum G-Code ProgramingReplies: 12Last Post: 06-15-2006, 05:01 AM -
Alarm 160
By quatturbo in forum Haas MillsReplies: 4Last Post: 02-26-2006, 07:27 PM
Posting Permissions
