[quadbob]

I did the internal self diagnostics that Anilam 1400m uses. I got an error code"FFFF" in the hard disk surface test. Does anyone know what it means. I would gues it means there is a bad sector on disk, but what does one do about it. There is nowhere in the manual that explains any of the diagnostic tools available. Thanks.

[bdambacher@dsl.]

If the control works i would not worry about it. I think the product was not quite "finished" so i would not trust the diagnostics too much.. it is obsolete now

[Saddletramp1200]

Hi, I need the software for a TW 105 RH mill. The table will not home X axis. Is there a diagnostic built into the program? The table goes the wrong way when homing and shuts the servo off. Please help!:drowning:

[elkflugan]

I am trying to understand Anilam 1400M, which I have on my bed mill. This is my first CNC machine and I need a starting point so I can get going and make some parts. Can someone give me a hand?
9516521148

[bertcnc]

Are you having difficulty operating the machine or programing it? Have you got a tool changer?

[bertcnc]

Hi, I need the software for a TW 105 RH mill. The table will not home X axis. Is there a diagnostic built into the program? The table goes the wrong way when homing and shuts the servo off. Please help!:drowning:

What version of software do you have? It is shown on the screen at power up. Does the Z home OK?