Has anyone had contact with Joakim since September the 5th.
Sven, do you have any to contact him through unofficial means? DanB has not been able to contact him either!
Mike
Has anyone had contact with Joakim since September the 5th.
Sven, do you have any to contact him through unofficial means? DanB has not been able to contact him either!
Mike
Now when you say it, I have some unanswered e-mails lately. It is the usual routine when there's a lot of work so I haven't noticed anything special. I can try to call his office tomorrow.
My guess would be that his vacation season is over and he's hard at work on the 5.1 beta. Hopefully that's it.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Yes, I was right.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I've been trying to get a hold of him for 15 days now with no email reply. Is he around right now?
All figured out
I think he's working hard at getting a service release out for madCAM 5.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)