[JMFabrications]

Hello,

Im looking for a quote to have the attached spacer machined. Should be a pretty simple lathe part, you can purchase 1" OD x .25" DOM steel tube which is a perfect size. The material just needs a face, chamfer, and part. We were cutting these on a bandsaw and machining them on a manual lathe but its just taking too long.

Specs:
Material - Carbon steel
QTY: 100
Tolerances - +/- .01
Chamfer size is not critical, just need to break the edge so its not sharp.

Feel free to ask any questions.

Jim

[Microshaped]

PM sent Thank You

Matt

[w.m.s.]

I would be surprised if mcmaster carr did not have that...

[JMFabrications]

I would be surprised if mcmaster carr did not have that...

Although they have everything in the world they don't have this exact spacer......ive checked haha. Thanks for the input though.

[w.m.s.]

Now this is .505 id, not sure if thats an issue but this sure is close. May be a little pricey. Most everything on there is quite a bit more expensive than everywhere else. Its even zinc plated!!

92415A153 at qty (10+) $10.46

[JMFabrications]

Now this is .505 id, not sure if thats an issue but this sure is close. May be a little pricey. Most everything on there is quite a bit more expensive than everywhere else. Its even zinc plated!!

92415A153 at qty (10+) $10.46

Thanks for looking, yea a bit more than I want to spend but it could always be used as a backup if Im in a pinch.

[smcdonn]

Hello,

Im looking for a quote to have the attached spacer machined. Should be a pretty simple lathe part, you can purchase 1" OD x .25" DOM steel tube which is a perfect size. The material just needs a face, chamfer, and part. We were cutting these on a bandsaw and machining them on a manual lathe but its just taking too long.

Specs:
Material - Carbon steel
QTY: 100
Tolerances - +/- .01
Chamfer size is not critical, just need to break the edge so its not sharp.

Feel free to ask any questions.

Jim

Sent you a quote.

[JMFabrications]

Quote has been filled, thanks to everyone who submitted a bid!