Now that I have my spindle running, I am now at a point to load up the tool-changer when I came across the documentation that the pull-studs for this spindle requires a CAT40 60 degree angle :-(
Does anyone know if this machine will work (or hurt the machine) using the regular 45 degree angle on the pull-stud (retention knob)? (60 degree retention knobs will take a couple weeks and I do currently have 45 degree ones)
The tech at Milltronics wasn't confident enough but was skeptical that you could since a bearing style drawbar was used inside the spindle with these machines.
Thanks again for all the help!
Sam.