Hello,
We got an issue. Our machine efficiency is decreased. Machine model is Robofill 330F Our cutting speed went down now. We are thinking that the problem could be the generator voltage problems. The question is how to get to the generators parameters and maybe there is any table with information with normal cutting parameters we would like to compare information. A few months ago accidentally
we had reset all parameters, but fortunately we made backup of parameters. But now the machine is cuts slowly and the wire breaks often. We compared same model machine in other company and they cuts contour for example in 30mm high steel plate in 14 000 feed rate and our machine cuts for example just 0,800 for example.
Any suggestions?
Thanks a lot for any information

Here some photos with parameters :

http://1.1m.yt/6lgd_Az.jpg
http://1.1m.yt/F9MEIl-.jpg
http://1.1m.yt/uCCnI4e.jpg
http://1.1m.yt/199CIqH.jpg