586,036 active members*
3,576 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Novakon > NM-145- need config file (XML?)

Thread: NM-145- need config file (XML?)

Results 1 to 3 of 3
  1. 10-06-2016, 04:54 PM #1
    steveb946
    steveb946 is offline Member
    Join Date
    Feb 2009
    Posts
    51

    NM-145- need config file (XML?)

    I have a corrupted config file for my NM-145 mill.
    Could someone send me a proper file for this?

    Thanks, Steve Bell
    Reply With Quote Reply With Quote
  2. 10-06-2016, 05:31 PM #2
    SCzEngrgGroup
    SCzEngrgGroup is offline Gold Member
    Join Date
    Feb 2006
    Posts
    7063

    Re: NM-145- need config file (XML?)

    Have you contacted Novakon? I'm sure they could easily send you one....

    Regards,
    Ray L.
    Reply With Quote Reply With Quote
  3. 10-06-2016, 08:20 PM #3
    steveb946
    steveb946 is offline Member
    Join Date
    Feb 2009
    Posts
    51

    Re: NM-145- need config file (XML?)

    Quote Originally Posted by SCzEngrgGroup View Post
    Have you contacted Novakon? I'm sure they could easily send you one....

    Regards,
    Ray L.
    Yes, I left a message for Novakon. It turns out that I found an old backup XML file here, and it did not solve the the problem of motor steps per inch. I will start a new thread on that topic
    In the mean time, I will re-install MACH3, just in case.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Config file for Series 3 Tormach
    By mike sr1 in forum LinuxCNC (formerly EMC2)
    Replies: 1
    Last Post: 04-16-2014, 05:40 PM
  2. Anyone have a config file for HY-JK02-M breakout board?
    By Galane in forum LinuxCNC (formerly EMC2)
    Replies: 0
    Last Post: 09-22-2013, 02:41 AM
  3. syil x4 speedmaster config file
    By gazzer in forum Community Club House
    Replies: 0
    Last Post: 09-02-2013, 09:57 AM
  4. Mach3 Config file
    By ltcjr71 in forum Charter Oak Automation Support Forum
    Replies: 7
    Last Post: 12-17-2010, 02:57 AM
  5. Mach 3 driver config file
    By Drakkn in forum Mach Software (ArtSoft software)
    Replies: 6
    Last Post: 08-10-2007, 08:17 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules