Ok, got the upgrade all done and while checking tramming my spindle was off on the x travel by .002. I used the edge tramming guide and zero'd the lateral travel to dead on thanks to the tramming plate nut and a slow tightening of all the bolts
I then repeated the steps for the Y travel on the gantry as outlined in the edge manual, and found that its off a hair under or a needle off .001. To adjust that means loosening all the gantry bolts and trying to tilt it get it perfect.
My gut says thats not going to be easy and in fact I may wind up with that off by more. What say you have you found that you get it perfect dead on or is .001 acceptable. I'm kinda anal on that kinda stuff but wonder if its really going to be necessary.