Cannot figger out the coding to repeat a sub on this control.
Book doesn't mention it at all, and coding for the 900 doesn't work either.
(CLS, L1, ?xxx)
R99 does not work.
The code above without the ?xxx does work, just won't loop.
Cannot figger out the coding to repeat a sub on this control.
Book doesn't mention it at all, and coding for the 900 doesn't work either.
(CLS, L1, ?xxx)
R99 does not work.
The code above without the ?xxx does work, just won't loop.
Have you tried (CLS, L1, 99) where just 99 is the number of repeats?
Beege
Is your subroutine local (as in (DFS, L1)~~(ENS) or a separate registered program? A local program should be (CLS, L1, 99) and a separate program would be (CLS, 1, 99) where the "1" would be the program #. I've read that some controls don't support the repeat.
I am running local in this case.
Really?I've read that some controls don't support the repeat.
The 900 (10 yrs older) was able to repeat.
But it wasn't able to run local AFAIK.
I could try spinning the routine off and calling it that way - and then maybe a repeat will work.
???
.
.