[Peruanzon]

Hello friends, tell them I have a cnc router with DSP control and has emerged me a doubt and is steps from the XYZ axes, the least I could do go manually (by pressing the buttons on the DSP) is 0.1mm, and sometimes I can not center well because 0.1mm is much forward motion for centering small letters, maybe if 0.05mm would be excellent, but not as you can configure, does anyone know about this?
Thank you very much and if you do not understand my question I make a video, let me know

[Big S]

You should be able to change the distance of the steps in settings

Shannon.

[Peruanzon]

I thank you for your answer, the problem I do not know how to do you can tell me how to be configured?

[Big S]

If you push the menu button there should be a list that comes up, can you find anything that is similar to "step units"? Depending on the menu file installed you might not be able to change it?

Do you have the handset host program installed on your computer?

Shannon

[Peruanzon]

You can see this video? steps are set to 0.5mm and 0.1mm,
https://youtu.be/IYATalTP9Tk
I would ask if you help me step by step, you can see the options in the video2
https://youtu.be/kLM01e9jsgc
Thanks

[Big S]

I made up my own menu files to access the ability to change the step setting.

A workaround is to use the Dist (Distance) mode and set it to 0.05mm. Then you can move in smaller distances.


Shannon

[Big S]

I just remembered how to change the step settings easily

If you have it set to low step, then push the "STOP" button. Push the 'X-' button 3 times and you can change the step distance there. Push the 'RUN/PAUSE' button and then type in your setting and press the "ORIGN/OK" button to save the new settting.