Hi,

I just started my first try with fengrave(v1.55)...i am doing a cleanup pass after my intial vcarve and for some reason is does not line up properly with the first v cut pass

it looks almost like it needs to offset more by the amount radius of the bit...

i overlaid the cleanup pass in magenta on top of the vcarve for reference to see what i mean. It needs to move over in x and y, you can see that the gap on the bottom and left side is not correct. And also the angled magenta lines did not retract when it traveled those so it cut through all of that.

I cut my first vcarve pass, loaded the clean up pass leaving my x and y origin untouched and simply rezeroed for the new tool.

has anyone else experienced this?