Hello Everyone,

If you were using a Hunayang plugin for Mach3 to control VFD/spinde or using Spindle Talker than this macro's for you. I didn't add actual RPM yet but I will.

Only set up in UCCNC is in configuration, set spindle velocity min to 8000(rpm) and max to 24000(rpm). Any setting below it wont set frequency. Go to Macroloop set up and add M1092 with autorun.

If you used HY plugin you should already have these settings for HY VFD but here's a reminder.

PD163 is set to 1
PD164 is set to 1
PD165 is set to 3

Attachment 338246