hi , how are you ? i'm happy to right this message on your forum .
please can you help me whit this problem :
i dont know what is the proble whit the cnc i give it the work on right and it do the left work !!!
please i need your help
thank you .
hi , how are you ? i'm happy to right this message on your forum .
please can you help me whit this problem :
i dont know what is the proble whit the cnc i give it the work on right and it do the left work !!!
please i need your help
thank you .
please someone help me
What type of CNC ? laser, wirecut, mill etc ?
if milling.... guessing at possible leadscrew play...ie leadscrew nut, thrust bearing, joint with axis drive motor
( if your arrow is pointing in the X- direction.......the Y axis is what could be the problem )
Push / pull the table ( use a dial indicator ) to see if you have movement
fouzdo9
Post your program
Mactec54
Looks as though you may have your X axis Dir signal 'upside down'. Go into Ports&Pins and reverse the active state for that pin.
Cheers
Roger