[VladJb]

So I have a Fanuc 0-MD control on my mill and when I go to my wear settings menu it adjust my tool only in the Z direction, not in dia or rad. I set my tool hight offsets in the geometry, I don't think I need a second menu to adjust it. Is this a Parameter issue?

[samu]

You have to use different offset number for length and radius and if the offset is used with H word in program it is in Z(length) and with a D word it is in X-Y(radius). If you have 20 tool in your tool changer, you can use offset 1to 20 for length and 21 to 40 for radius.

If you work with T1 your prog looks like this:

M6 T1
xxx
xxx
xxx
G43 H1 Z1. M8
xxx
xxx
xxx
G41 X2.123 Y3.456 D21