Originally Posted by
turbina
Message for FreakCNC and Ncrazyballa:
DM3000 Old SKIP Controller is replaced by Mach3 + EZ-DM3000, the rear electrical panel does not even open, the SKIP Controller is disconnected and the EZ-DM3000 is connected, which is connected to the PC by parallel port, it does not work on the DM3000H, so far that I know not has never been tried with Mach4 or LINUX-CNC, but it should work.
Probably the mapping of the I / O on the Distribution Board of DM3000H is different that DM3000 which has 32 outputs and 16 inputs, I think however that modifying the EZ3000 firmware can be done because the SKIP motion controller and the connection cable are identical.
I have the DM3000H service manual but it doesn't contain the information I need, so for now I don't feel like giving you an EZ3000 because it probably won't work on the DM3000H