hello everyone , never posted here before so bare with me. recently aquired an emco compact 5 cnc , red and grey in colour so i belive its a later model, took the back cover off and someone at some point in time has installed a wellturn card into it. i disconnected it because they are no longer supported but i think the rest of the boards are still intact.i have searched high and low for some pics to see what it should look like but none out there, however i believe there might have been a vcb board on here at one time but its gone . the cables seem to be there though.so what im looking to do is either try to bring this somehow back to life or maybe a total refit with new steppers as well. has anyone done any of this and what might be the most economical route??