586,116 active members*
3,511 visitors online*
Register for free
Login

Thread: Slave Axis Moves Slower Then Other

Results 1 to 2 of 2
  1. 12-26-2016, 05:02 PM #1
    minicncuser
    minicncuser is offline Registered
    Join Date
    Dec 2014
    Posts
    103

    Slave Axis Moves Slower Then Other

    i cant get motors to move same speed when wired right
    if i send output from y to both Drives works fine
    but i would like to wire it right and home each one
    Mach3 setting the same on all 4 axis
    Motor tunning setting the same
    New laptop
    Mach3
    E Smooth Stepper
    5axis breakout board
    4 60 volt power
    1 5 volt
    Reply With Quote Reply With Quote
  2. 12-27-2016, 03:16 PM #2
    minicncuser
    minicncuser is offline Registered
    Join Date
    Dec 2014
    Posts
    103

    Re: Slave Axis Moves Slower Then Other

    it was the speed setting in the ess plugin config
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Phoenix USB CNC Controller 3 Axis plus 4th Axis Slave Output by Hayri Uygur
    By iHayri in forum Controller Cards
    Replies: 0
    Last Post: 11-13-2015, 04:37 PM
  2. Slave axis motor turning slower only sometimes.
    By andyn08 in forum Mach Software (ArtSoft software)
    Replies: 3
    Last Post: 08-08-2014, 04:08 AM
  3. Dual Y Axis Slave A Axis Homing Problems
    By guy2b1 in forum Calibration / Measurement
    Replies: 4
    Last Post: 03-03-2012, 11:06 PM
  4. X axis travel rate is 50% slower than Y
    By Inuk in forum Stepper Motors / Drives
    Replies: 0
    Last Post: 12-29-2010, 08:21 PM
  5. X axis runs 50% slower than Y
    By Inuk in forum Excitech routers
    Replies: 0
    Last Post: 12-27-2010, 03:05 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules