Is there a way to select how the G code is created?
Id like to run a part in incremental mode because i want to tweak the G code afterwards and its would be much easier in incremental then absolute mode.
Is there a way to select how the G code is created?
Id like to run a part in incremental mode because i want to tweak the G code afterwards and its would be much easier in incremental then absolute mode.
In Aspire? I don't believe so.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
If you are using Mach3 for a controller you can change between them there in the settings, if that will work for you.
Mike