I'm retrofitting a boss 5 and the z axis motor wiring does not look like the x-y motors. I ohms tested coils and I get .7 ohms between the following. 2-3 4-8 5-6 1-7. How do I connect this motor?
I'm retrofitting a boss 5 and the z axis motor wiring does not look like the x-y motors. I ohms tested coils and I get .7 ohms between the following. 2-3 4-8 5-6 1-7. How do I connect this motor?
Which motors do you have? Superior or Sigma? Round terminal arrangement or square terminal arrangement? What type of motor driver are you using? 4 wire bipolar (series or parallel), 6 wire unipolar? There are lots of different ways to hook up a motor.
I think I did them parallel. There was a long discussion from BOSS5 about this.
Most wire them in parallel with a bipolar driver.
Sent from my iPhone using Tapatalk