John, this is the board...
https://cnc4pc.com/c10-bi-directiona...face-card.html
John, this is the board...
https://cnc4pc.com/c10-bi-directiona...face-card.html
thats another version of the C10 I have not seen before
a surface mount version of the old BOB with screw terminal blocks
rev1 without the 74LS00
Attachment 371708
C10 Rev 10
on the new C10 it looks like they have saved a 74ACT245 octal buffer by using one to buffer the 8 date lines instead of half of two IC's as on the old board
Attachment 371710
the circuit should be very like the one I posted in post 14
but now has an output status LED to the output enable
John
Yah, it's just weird, I ordered one thing got something else, no real explanation of what's different or even how to use it, very disappointed..
After I test the ports, if that looks good all the way through, then I'm looking at drivers... Not buying again from them!!!
I am not sure when I produced this diagram to answer a question on CNCZONE
to show the function of the jumpers
this shows the signal path for the step and direction signals to a 5056D driver - will apply to many opto-isolated drivers
Attachment 371744
this is what I expect your new board will be
Attachment 371746
John