So iam now going down the road of wiring my X,Y,Z servo drives(DMM- TECH) STEP & DIRECTION signals to my Dynomotion boards. The drives have I/O connector JP4 with Pin 10 (DIR-) Pin 11 (PUL+) Pin 22 (DIR+) Pin 23 (PUL-). (Also, i dont understand having the 2 different polarity STEP & DIR signals.)
The Input Circuit Reference in drive manual states that Voltage is + 5VDC +/- 10% and if higher voltage such as 12/24VDC is needed , to contact them. Is there a way to use the 24VDC option for STEP&DIRECTION and where would i wire these connections to on my Kflop, Kanalog, Konnect combo?
Troy