Hi Tom,
It should be ok. Just make sure your Screen Script is configured in KMotionCNC...
What do you mean configured in KMCNC?
Back to the FeedHold issue before...
When you push the Feedhold button does Bit 58 (the Feedhold LED) always come on?
Only when the FeedHold actually happens.
Is this printed on the console? printf("Decel time = %f\n", CS0_DecelTime);
When the FeedHold actually happens.
I see the CycleStart button turns off FeedHold. Is there noise or something on it? You might comment out the ResumeCoordinatedMotion(); to see if it is the culprit.
Has no effect. The FeedHold still does not happen.
Using the Gcode below see notes where the FeedHold will not work or is very delayed. Tested with INIT v3.5 with no FeedHold problems.
Code:
%
O1001 (45MILLTESTFIN)
(T5 D=0.5 CR=0.005 - ZMIN=-0.425 - BULLNOSE END MILL)
N1 G90 G94 G17 G49 G40 G80
N2 G20
N3 G53 G00 Z0.
(2D CONTOURFINISH 2)
N4 T5 M06
N5 S2500 M03
N6 G54
N7 M08
N8 G00 X0.9137 Y-1.3892
N9 G00 G43 Z1. H05
N10 G00 Z0.2
N11 G01 Z0.0394 F5.<<<FeedHold fails here
N12 G01 Z-0.425
N13 G01 G41 X1.1887 Y-1.3392 D05 F20.<<<FeedHold fails here,sometimes
N14 G03 X0.8637 Y-1.0142 I-0.325 J0.
N15 G01 X-1.1363<<<About halfway threw this move FeedHold will not work.
N16 G01 X-2.575 Y0.4245
N17 G03 X-3.0346 I-0.2298 J-0.2298
N18 G01 G40 X-2.8755 Y0.1947
N19 G00 Z1.
N20 M09
N21 M09
N22 M05
N23 G53 G00 Z0.
N24 G49
N25 G53 G00 X11. Y0.
N26 M30
%
Also, in order for me to get v3.6 to compile i changed this line....
#include "c:\KMotionSrc\C Programs\KflopToKMotionCNCFunctions.c"
to this...
#include "KflopToKMotionCNCFunctions.c"
Troy