[bobancurug]

Hi Bip,

below is a backup of my parameters, I hope that will be the same for your machine as well. As far as I know, they are mostly all the same hardware and machine options. These are old, simple machines and there should not be too many differences between the machines.

[bip1988]

Thankyou bobancurug for your reply, it's much appreciated.

These parameters have helped and have me closer to getting this machine running.

My next issue is i think the machine is set to an 8 tool station, however we have a 12 tool. I'm thinking that this may be set through one of the diagnostics. I can MDI T0101 through to 8, however 9-12 do not work. I found someone who sold me the parameters/diagnostics for other machines that are similar, however as i look at the supplied photos, all these machines have an 8 tool turret.

Any ideas?

[Hardplates]

Thankyou bobancurug for your reply, it's much appreciated.

These parameters have helped and have me closer to getting this machine running.

My next issue is i think the machine is set to an 8 tool station, however we have a 12 tool. I'm thinking that this may be set through one of the diagnostics. I can MDI T0101 through to 8, however 9-12 do not work. I found someone who sold me the parameters/diagnostics for other machines that are similar, however as i look at the supplied photos, all these machines have an 8 tool turret.

Any ideas?

D435.7 will enable the 12 station turret.

FYI holding EOB while pressing output will punch out the 900s

[bip1988]

Thank you, confirmed this worked.