586,096 active members*
3,741 visitors online*
Register for free
Login
IndustryArena Forum > WoodWorking Machines > DIY CNC Router Table Machines > need some help deciding on a NEMA 34 electronics kit

Thread: need some help deciding on a NEMA 34 electronics kit

Results 1 to 3 of 3
  1. 02-22-2017, 10:23 AM #1
    HJB808
    HJB808 is offline Registered
    Join Date
    Feb 2017
    Posts
    1

    need some help deciding on a NEMA 34 electronics kit

    Hello everyone,
    New to this whole CNC thing, but I am excited to get my build underway. I am building a 4x4 unit. I am not sure of what electronics kit to purchase. Was looking at CRP DIY kit, but I am wondering if there are better options available. A little unsure about the Longs kits on ebay,(support, wiring schematics, etc)

    Any assistance would be greatly appreciated. Also If anyone has a clear wiring schematic to share that would be awesome!!!

    Thanks
    Reply With Quote Reply With Quote
  2. 02-22-2017, 10:35 AM #2
    minicncuser
    minicncuser is offline Registered
    Join Date
    Dec 2014
    Posts
    103

    Re: need some help deciding on a NEMA 34 electronics kit

    I made a 4x8 bought nema 34 1600 oz stepper motors kit replaced with stepper with nema 23 320 oz used the drivers form kit the bigger motors gave me so much problems
    Reply With Quote Reply With Quote
  3. 02-22-2017, 04:06 PM #3
    CNCArtD
    CNCArtD is offline Registered
    Join Date
    Jan 2017
    Posts
    33

    Re: need some help deciding on a NEMA 34 electronics kit

    I bought the Longs motors 1600 OZ Inch fit from ebay and run them with the planet cnc software and driver board. And it works flawlessly. Have never lost a step yet.
    Artistic 3D Relief Work for CNC http://www.cncproductionwork.com
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Nema 34 Electronics Kit question - Relay 1 -out
    By bonesbr549 in forum Stepper Motors / Drives
    Replies: 1
    Last Post: 04-28-2016, 09:10 PM
  2. Nema 23 Electronics Kit with ESS
    By Op4 in forum Avid CNC
    Replies: 1
    Last Post: 04-13-2015, 05:34 AM
  3. 23 Nema Electronics Kit and VFD Control
    By Op4 in forum Avid CNC
    Replies: 6
    Last Post: 04-13-2015, 03:53 AM
  4. Building the CRP Nema 34 Panel and electronics kit
    By FoxCNC1 in forum Avid CNC
    Replies: 5
    Last Post: 12-06-2013, 05:11 PM
  5. Deciding what to use for small electronics enclosure (aluminum extrusion?)
    By TZAdvantage in forum MetalWork Discussion
    Replies: 3
    Last Post: 07-26-2013, 03:22 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules