Hello all,
I'm doing a lot of rotary 4th milling and my A axis needs to unwind a few times in long jobs. I'm using a HAAS TM -3P and the exported Bobcad code is below. This unwind takes a few minutes but I can go in manually and use the commands:
G91 G28 G00 A0.
G90
G92 A(Whatever value I need).
In place of the unwinding process. Is there a way to make the post processor do this for me?
Thanks!
Original Output:
N13865 X-1.2799 Z3.6561 A-9993.762 F3482.2216
N13866 X-1.2798 A-9994.212 F9999.
N13867 X-1.2792 Z3.6563 A-9996.012 F3482.208
N13868 X-1.2785 Z3.6561 A-9997.812 F3482.2091
N13869 X-1.2782 Z3.6558 A-9998.712 F6964.5613
N13870 X-1.2781 Z3.6557 A-9999. F9999.
N13871 G00 Z13.6557
N13872 A-9954.
N13873 A-9909.
(AND SO ON)
N13965 A-5769.
N13966 A-5724.
N13967 A-5679.
N13968 G01 G94 Z3.6557 F400.
N13969 G93 X-1.2778 Z3.6563 A-5680.063 F5899.6854
N13970 X-1.2771 Z3.6562 A-5681.863 F3482.198
N13971 X-1.2765 Z3.656 A-5683.663 F3482.3207