I need to cut a bearing seat into the end of a piece of 4130 tube. The tube is 1/2 inch with an 0.083 wall. So that's .5000 OD and .3440 ID. The seat needs to be 0.3745.
I can drill and ream to .374, but I need to get that last .0005, without going over. I can't get any boring tool I have into that small a space. I would appreciate any suggestions you guys might have.
Results 1 to 4 of 4
Threaded View
-
03-07-2017, 12:44 AM #1
Registered
- Join Date
- May 2015
- Posts
- 17
cutting a bearing seat in 4340 tube
Reply With QuoteSimilar Threads
-
Steel pipes cutting round tube and squre tube , fiber cutitng is best ?
By laserliu in forum Laser Engraving / Cutting Machine General TopicsReplies: 0Last Post: 02-23-2017, 10:42 AM -
Car seat cover laser cutting machine introduction
By Dekcelcnc in forum Laser Engraving / Cutting Machine General TopicsReplies: 0Last Post: 01-27-2016, 08:32 AM -
Bearing Seat
By bmurph in forum Employment OpportunityReplies: 7Last Post: 03-23-2010, 10:04 PM -
Tube cutting; tin slots and tube ends
By marineboy in forum Waterjet General TopicsReplies: 0Last Post: 10-13-2009, 10:03 PM
Tags for this Thread
Posting Permissions
