Could someone have a peek at this please. I posted earier but not sure if it went through.Thanks.
Could someone have a peek at this please. I posted earier but not sure if it went through.Thanks.
Looks basically OK, although there should be an inclusion in it for E-stop shut off.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Thanks Al now coming from a newbie to all this does the estop get wired inline on the white side. This is one of the components i did not look into. Thanks
In the power side same as the fuse conductor, it is not normal to switch the neutral or usually necessary to also switch the N..
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Thanks Al will do.
Attachment 355448layout so far. Im thinking motor connectors directly above drivers. And pp north of drivers. Still need estop.
Here is a pic with estop Attachment 355512
That would work but usually it is incorporated with one that also shuts the spindle off.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
I dont think ill control tbe spindle Al. Here is the estop switch, it has two sides the red and green do i connect straight through on the red or the green im a little co fused or second guessing myself.Attachment 355542
Normally use the Red side it is N.C. that is the one you use, Green is N.O.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Thanks for your help Al. Here are some pics not done yet.
Attachment 355682Attachment 355684Attachment 355686Attachment 355688Attachment 355688Attachment 355690Attachment 355692Attachment 355694