[BRATTEN82]

I was wondering if there is a way to increase how high the router lifts after it is done cutting one part to travel to begin cutting the next one. I've tried to figure out something but with just getting the program I can't figure it out, or maybe there isn't a setting for it. if anybody could help me id appreciate it.

[propellanttech]

Are you talking about in Lazy cam? Because if you are talking about with G code, that would need to be in the code.

James L

I was wondering if there is a way to increase how high the router lifts after it is done cutting one part to travel to begin cutting the next one. I've tried to figure out something but with just getting the program I can't figure it out, or maybe there isn't a setting for it. if anybody could help me id appreciate it.

[BRATTEN82]

thank you I totally figured it out now that you said that. I appreciate it been knocking my head against the wall.

Are you talking about in Lazy cam? Because if you are talking about with G code, that would need to be in the code.

James L