I've had the task of getting an OKK PCV60 with a Fanuc O-M controller to communicate with a PC via serial port assigned to me and know nothing about running the controller. The only person who did know has left the company. We need to send programs from the PC to the machine and haven't been able to get that done. I have been able to determine that the communication parameters are right on both ends. I can also see that there are three programs in the controller now and I don't know how to remove them.
Can someone give me step by step directions for sending a program from the PC to the controller starting with turning on the machine and controller?
Thanks much,
derail
Results 1 to 3 of 3
-
02-26-2007, 05:58 PM #1
Registered
- Join Date
- Feb 2007
- Posts
- 1
Send program from PC to Fanuc controller
-
02-26-2007, 10:14 PM #2
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24223
I would suggest you get at least an operators manual, as it seems that RS232 communication is going to be the least of your worries.
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
-
02-26-2007, 10:15 PM #3
Gold Member
- Join Date
- Oct 2004
- Posts
- 742
Here is a post that gives info on the subject.
http://www.cnczone.com/forums/showthread.php?t=31491
Reply With Quote
Similar Threads
-
how configurated mastercam x to send a program?
By alain aleman in forum Post Processors for MCReplies: 1Last Post: 12-31-2006, 08:59 AM -
MasterCam 9 send program problam
By Biladon in forum FadalReplies: 8Last Post: 11-15-2006, 02:44 PM -
fanuc 3t wont send prog.
By AFX in forum FanucReplies: 5Last Post: 10-07-2006, 01:25 AM -
looking for send program to cnc;
By raymon in forum DNC Problems and SolutionsReplies: 4Last Post: 08-22-2006, 04:35 PM -
New CNC Controller Program for DOS
By manfong in forum News AnnouncementsReplies: 10Last Post: 10-10-2003, 05:30 PM
Posting Permissions
