[miguisu]

We received a MORISEIKI SL-35 lathe, and i cannot find the way for change the chucking direction. I mean, i need to use jaws for holding the spare parts, but from i.d.
So, i need to change it because the machine doesn´t run, of course. Can anybody help me, please as soon as possible? i couldn't find any command on the operators panel for it. The control is a FANUC 16 t
Thanks for your assistance !!!!
MILTON SUAREZ

[cncdigger]

I have an old Mazak ST-15 with FANUC 6T and the chuck ID/OD switch is located (hidden) in the rear electronics panel. Not very handy. That's all I can tell you.
You would think that with the evolution, Fanuc woud have made it easily accessible thru operator accessible parameter. I know Haas did. But then again, Haas is very user friendly. Can't say that for Fanuc.

Al.

[jackson]

look for the key, but on some moris you have to go into a setting its been along time since i ran one so im not sure were it is but look through the control you should find it