[Tancuda]

Hi all,

at the shop, on a 5 axis mill with fanuc 31i, the operator ask me if I could help him with the Manual guide i,
so trying to help him but my problem is that I can't see the START, CYCLE, END etc...softkeys !!

See attached pic, I can't see what 's in the red rectangle.

Any tip ??

thanks a lot

[mbservice]

what you cant see them on the screen

[Tancuda]

No I can't see these softkeys on the screen !!

[PEGBOARD]

Hi, are you in edit mode and use the left/right softkeys to scroll through the different softkeys. there is parameter values to change these keys but they should be set by default.

[Tancuda]

Yes in EDIT mode, did try left and right, and parameter 14700 #7MGI is 0, so Manual guide is enable....

[PEGBOARD]

Could you post a snapshot of your screen display whilst in Manual Guide mode.

[Tancuda]

Yes i can, but not at the moment, I'll do it as soon as I can

Thanks for your time