Hello,
Just getting things setup up and running with the new hardware/software.
I had the system up and running with Mach3 and through the parallel port.
I was loosing steps due to the PP card issues.
I got a hold of a smoothstepper for a week and had it running with a couple of clicks.
Everything works no wiring issues...
-----
Now I have a UC300ETH-LPT5 and the software loaded up and plugged in, UC300 detects (And flash auto updated)
Everything powered up, everything connected and I created a new profile and imported my Mach3 profile.
(PP cable plugged into port 1 of the UC300)
The limit switches work. The emerg stop works. The probe works (all signalling correctly through the Diags page)
The motors lock up, but wont turn? Can't get the spindle to cycle on/off.
I can't change the STEP/DIR pins, when I change them and click apply, they revert back to zero.
Thoughts?
Thanks!
Results 1 to 20 of 30
Threaded View
-
04-06-2017, 04:11 AM #1
Junior Member
- Join Date
- Jan 2008
- Posts
- 241
Converting to UCCNC & UC300ETH-LPT5 (From Mach3/PP/SS)
My Build: http://www.cnczone.com/forums/diy-cnc_router_table_machines/113711-my_build_-_many_thanks.html
Reply With QuoteSimilar Threads
-
Swap Mach 3/ESS for UCCNC/UC300ETH-5LPT on CRP PRO with Plug and Play Electronics
By skrap853 in forum Avid CNCReplies: 76Last Post: 03-27-2023, 11:26 PM -
uccnc or mach3
By eldons in forum UCCNC Control SoftwareReplies: 2Last Post: 04-02-2017, 06:31 PM -
UCCNC and UC300ETH - A real scary speed monster.
By A_Camera in forum UCCNC Control SoftwareReplies: 51Last Post: 11-24-2016, 06:21 AM -
Mach3 plugin is now available for the UC300ETH
By A_Camera in forum UCCNC Control SoftwareReplies: 0Last Post: 11-11-2016, 09:45 AM -
UCCNC and Mach3 Modbus MPG?
By Signal9 in forum UCCNC Control SoftwareReplies: 5Last Post: 09-19-2015, 07:42 PM
Tags for this Thread
Posting Permissions
