Quote Originally Posted by agelkom View Post
***************
Hi Argun,
Some components are mising in your component list (IC4, IC5, R11A, R12A, R46, R50-R52). Can you post full component list? Also I found discrepancy between schematic and pcb. In schematic resistor R51 attached to pin 4 of IC5, on pcb to pin 3. Can you check which is right?
Regards,
Romas
***************
Hi Romas,
Sorry,
Component list attched.
R51 an IC5's photo diode are in series, there is no difference R51 position. The differences may occur during PCB drawing.
Regards
Argun
Hi,
Lini8 charge-pump modification appears to work only for Linistepper Version 1, with Enabled is High. In Linistepper Version 2, however, Enabled is active low. Any suggestions on how to make Lini8 modifications work with Linistepper Version 2? Best regards.