I have been troubleshooting this issue on my HY02D223B 2.2Kw VFD for the past few days and have read pretty much any thread or article I can find on the issue. I have gone over all of the settings and performed a factory reset several times. I have checked the resistance between the three windings as well as each winding and the ground. I am getting .8-1.6 between each winding and no reading from each winding to ground. The Amp readout on the VFD keeps climbing when I press the 'Run' button. It cuts off at 12 Amps and gives a EoCA error. My current settings are:
PD000 - 0
PD001 - 0
PD002 - 1
PD003 - 400
PD004 - 400
PD005 - 400
PD006 - 2.5
PD007 - .5
PD009 - 13
PD010 - 6.5
PD014 - 10
PD015 - 10
PD041 - 8
PD071 - 20
PD072 - 400
PD073 - 0
PD141 - 220
PD142 - 8.5 (from motor plate)
PD143 - 2
PD144 - 3600
I have uploaded a video to YouTube to show the error.
https://youtu.be/hF317z1Ms4o
I have also included pictures of the current wiring set up and a red LED that is on and visible through the top of the VFD. The LED is in the upper right of the last picture
Any help would be great!
Nate