Before sending a job, are you able to tell VCP
what the cutting order is in a given object(s)? See Pic
or does it decide what to do.
I work with Enroute 3/5 so Im use to that setup.
The ordering they have is Rows / Columns / in~out / out~in / Manual
I cannot do the trial because of XP and issues. Wont install even w/ SP3.
Also when it is doing a pocket job, does it work its way through
an area mid-way and then go to another area and so on like it's forgetting
something and then finally finishes the job? Trying to avoid the
almost 10x cost for Enroute.
Sorry for the dopey Q, it's just one of those quirks when something
is routing/engraving and the machine does its own thing unexpected.
I'll try the VCP trial when I get to work but wont be till next week.
Thanks
Ronnie