hello guys
i will be doing diy edm build soon.
it will be used to cut carbide
only one axis design though, but it meets my needs
i am currently gathering parts and decided to use RC circuit style with arduino feedback
the problem is, it is such a small design, that using conventional diamond guides forces me to make it bigger.
however, if i use edm drill guide, it is veryshort(>25mm), so it allows me to build the micro edm with small footprint
would edm wire sizes ex)0.1mm, and 0.25mm fit into these?
i know diamond guide sizes and such that, it is 5 microns bigger than the wire sizes.
i am not too sure if edm drill guides are the same.
i am aware drill edm are not diamond, usually ruby or ceramic, but for my application it is not too critical.
please do share your experience with this situation
thankyou