[regina]

Fanuc 0MC 32 bit, any way to run with 6050 analog ac servos? I know tc429 talked about doing it, but I don't know how, and have not been able to contact him
http://www.cnczone.com/forums/archiv.../t-240422.html
I know there is an incremental axis board for the 32 bit, A16B-2200-0390 but don't know how to make that work with an analog drive,
There is a A16B-1212-0250 analog axis board, but it is listed as being for 16 bit.
I know I have been asking a lot of questions, but I need a few answers and don't know where else to turn. This stuff is not in my manuals, or if it is, I can't find it.
Please help

[guhl]

description says that A16B-1212-0250 runs with non 486 intel masterboards
may be A16B-2200-0290 suitable to you?

[regina]

Interesting! It might. Looks like it would physically fit in there. I don't see that board referenced anywhere. Do you have any info on it? It's not a robot board is it?
Thank you!!!!!

[guhl]

I suspect it's from robot. I don't have any info.

[regina]

I'm a bit hesitant to buy a board and plug it in with no info on it. Could it blow up the control/or the board? I know someone must have done this somewhere.

[guhl]

I don't think the hardware trouble may occur, in contrast from problems connected with software.