Good morning everyone The usual question no doubt! ...... I'm recently new to this cnc stuff, so all good advice appreciated.. I've gotten some Queensland Maple slabs, & want to make 'St...' style guitar bodies out of them.
After much research it seems that getting one CNC routed is the way to go for me for now. After consulting with CNC operators in Cairns, Australia area, showing them another similar bare body, I've been advised to get an accurate DXF body file, maybe other formats wouldn't hurt though, Though my searching on here I've only found 'vintage st...' files that would require mods...
What I'm after is a file for a body routed for H/S/H pickups, and top mounted 'floyd rose' polepiece holes & trem slot, so preferably with a few degree tilt back neck pocket.. I've searched here, and elsewhere for the correct specs in case someone else already had the exact same Q & A's, but to no avail.
Is there anyone here that has a same file or very similar that has already been tested? CNC operators in my area haven't yet done a guitar, but are savvy to what I'm after. They've told me of the headaches they encounter from other clients that have an idea & a file that doesn't work out.
What are your thoughts or solutions, people?