Hey folks, I could use a hand here. Occasionally, on our 2006 DMV 3016, the tool carousel/umbrella doesn't want to return home after a tool change. It goes slowly and then picks up speed or sometimes it doesn't even get going. You can give it a shove to get it going and then it returns. It may work well for a few cycles and then it sticks again. We have cleaned and lubed all the running surfaces and I am at a loss to explain it. It always comes forward with no issues. Ideas?
Results 1 to 2 of 2
-
06-21-2017, 09:17 PM #1
Registered
- Join Date
- Jun 2017
- Posts
- 1
Umbrella sticking on return after tool change
-
08-31-2017, 08:34 PM #2
Registered
- Join Date
- Sep 2007
- Posts
- 66
Re: Umbrella sticking on return after tool change
hi
i have the same thing with my Myxs NM510.
then when i push it up it does not want to go ,but if i try to pull it down it goes up in position .
greeting bertus
Reply With QuoteSimilar Threads
-
Mori MV-40B Zero Return Error on Tool Change Command
By blkaplan in forum Mori Seiki MillsReplies: 2Last Post: 02-04-2017, 12:18 AM -
Tools sticking in Spindle at tool change
By hatchmar in forum OkumaReplies: 10Last Post: 05-01-2012, 05:04 PM -
MIT 320 UMBRELLA TOOL CHANGE
By richard booker in forum Mazak, Mitsubishi, MazatrolReplies: 7Last Post: 04-10-2012, 06:49 PM -
Auto tool changer-Umbrella type tool magazine.
By maylin1105 in forum News AnnouncementsReplies: 2Last Post: 02-15-2012, 03:38 AM -
Tool Change Recovery VF3 Umbrella
By cncmaintenance in forum Haas MillsReplies: 1Last Post: 11-07-2008, 07:05 PM
Tags for this Thread
Posting Permissions
