Originally Posted by
originalsigns
I fallowed the manual and as far as I know the UC400eth is installed correctly. I have a blue light on and it said the drivers are already installed when I tried automatic installer again. I wrote a letter to CNCDRIVE and got a nice response (they are great in customer service, but their suggestion didn't get me anywhere) - they mentioned downloading .NET Framework 2.0 "If you have Windows 7 then you do not have to install it at all, because the .NET framework 2.0 is part of that Operating System, so it installs with Windows" well, I have Windows 7 - so I tried to do it anyway and I don't think it worked. I'll try it again - But I think I need to find a way to uninstall EVERYTHING and try again - what do you know about UCCNC? If I give up on Mach3, will I have the same issues setting that up? I just need to get my machine running - I'd rather buy and learn new software than keep going in circles. Do you think a guy from Geek Squad could figure it out? Anyway - sorry to ramble, any suggestions would be greatly appreciated. Thank you!