Re: Motion Controllers: Mixing Servos & Stepper Motors
I'm still alive and the offer is still good. My software will do just about anything you want it to do, including rigid tapping (at least I've done it on my lathe, not on the mill) My software works fine with the Fanuc, Haas, or Mach3 Fusion 360 posts (and actually most of the others also). For the lathe I use the Haas lathe posts.
In any case you are always going to have to have a translator between the G code and the controller no matter what controller you are using. Motion controllers have no idea what any length unit is, they only understand encoder or step pulses.
Jim Dawson
Sandy, Oregon, USA